PLANET WGSW-50040 User Manual
Page 418
ping failure which means unreachable link, while “!” for ping success, which means
reachable link.
Use ping command with source address configuration, and leave other fields to default.
Switch#ping src 10.1.128.161 10.1.128.160
Type ^c to abort.
Sending 5 56-byte ICMP Echos to 10.1.128.160, using source address 10.1.128.161,
timeout is 2 seconds.
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 0/0/0 ms
In the example above, 10.1.128.161 is configured as the source address of the ICMP echo
requests, while the destination device is configured to be at 10.1.128.160. The command
receives all the ICMP reply packets for all of the five ICMP echo requests. The success
rate is 100%. It is denoted on the switch “.” for ping failure which means unreachable
link, while “!” for ping success, which means reachable link.
Ping with parameters entered interactively.
Switch#ping
VRF name：
Target IP address：10.1.128.160
Use source address option[n]: y
Source IP address: 10.1.128.161
Repeat count [5]：100
Datagram size in byte [56]：1000
Timeout in milli-seconds [2000]：500
Extended commands [n]：n
Display Information
Explanation
VRF name
VRM name. If MPLS is not enabled, this field will be left empty.
Target IP address：
The IP address of the target device.
Use source address option[n]
Whether or not to use ping with source address.
Source IP address
To specify the source IP address for ping.
Repeat count [5]
Number of ping requests to be sent. the default value is 5.
Datagram size in byte [56]
The size of the ICMP echo requests, with default as 56 bytes.
Timeout in milli-seconds [2000]：
Timeout in milli-seconds, with default as 2 seconds.
Extended commands [n]：
Whether or to use other extended options.