PLANET WGSW-50040 - Manual (Page 296)

Commands for Security Function Chapter 6 Commands for TACACS+
no ip igmp snooping vlan <vlan-id> static-group <A.B.C.D> [source <A.B.C.D>]interface
[ethernet | port-channel] <IFNAME>
Function:
Configure static-group on specified port of the VLAN. The no form of the command cancels this
configuration.
Parameter:
vlan-id: ranging between <1-4094>
A.B.C.D: the address of group or source
ethernet: Name of Ethernet port
port-channel: Port aggregation
ifname: Name of interface
Command Mode:
Global Mode
Default:
No configuration by default.
Usage Guide:
When a group is a static while also a dynamic group, it should be taken as a static group. Deleting
static group can only be realized by the no form of the command.
Example
Switch(config)#ip igmp snooping vlan 1 static-group 224.1.1.1 source 192.168.1.1
interface ethernet 1/1
18.2.18 ip igmp snooping vlan suppression-query-time
Command:
ip igmp snooping vlan <vlan-id> suppression-query-time <value>
no ip igmp snooping vlan <vlan-id> suppression-query-time
Function:
Configure the suppression query time. The “no ip igmp snooping vlan <vlan-id>
suppression-query-time” command restores to the default value.
Parameter:
vlan-id: VLAN ID, ranging between <1-4094>
value: ranging between<1-65535> seconds
Command Mode:
Global Mode
Default:
255s