PLANET WGSW-50040 - Manual (Page 344)

Commands for Security Function Chapter 6 Commands for TACACS+
22.7 dot1x enable
Command:
dot1x enable
no dot1x enable
Function:
Enables the 802.1x function in the switch and ports: the "no dot1x enable" command disables the
802.1x function.
Command mode:
Global Mode and Port Mode.
Default:
802.1x function is not enabled in global mode by default; if 802.1x is enabled under Global Mode,
802.1x will not be enabled for the ports by default.
Usage Guide:
The 802.1x authentication for the switch must be enabled first to enable 802.1x authentication for
the respective ports. If Spanning Tree or MAC binding is enabled on the port, or the port is a Trunk
port or member of port aggregation group, 802.1x function cannot be enabled for that port unless
such conditions are removed.
Example:
Enabling the 802.1x function of the switch and enable 802.1x for port1/12.
Switch(config)#dot1x enable
Switch(config)#interface ethernet 1/12
Switch(Config-If-Ethernet1/12)#dot1x enable
22.8 dot1x ipv6 passthrough
Command:
dot1x ipv6 passthrough
no dot1x ipv6 passthrough
Function:
Enable IPv6 passthrough function on a switch port, only applicable when access control mode is
userbased; the no operation of this command will disable the function.
Command Mode:
Port Configuration Mode.
Default Settings:
IPv6 passthrough function is disabled on the switch by default.
Usage Guide: