PLANET WGSW-50040 - Manual (Page 97)

Example:
Specify the name of 1/1-2 port as financial.
Switch(config)#interface ethernet 1/1-2
Switch(Config-If-Port-Range)#name financial
3.1.9 negotiation
Command:
negotiation {on|off}
Function:
Enables/Disables the auto-negotiation function of a 1000Base-FX port.
Parameters:
on: enables the auto-negotiation;
off: disable the auto-negotiation.
Command mode:
Port configuration Mode.
Default:
Auto-negotiation is enabled by default.
Usage Guide:
This command applies to 1000Base-FX interface only. The negotiation command is not available
for 1000Base-TX or 100Base-TX interface. For combo port, this command applies to the
1000Base-FX port only but has no effect on the 1000Base-TX port. To change the negotiation mode,
speed and duplex mode of 1000Base-TX port, use speed-duplex command instead.
Example:
Port 1 of Switch1 is connected to port 1 of Switch2, the following will disable the negotiation for both
ports.
Switch1(config)#interface ethernet1/1
Switch1(Config-If-Ethernet1/1)#negotiation off
Switch2(config)#interface ethernet1/1
Switch2(Config-If-Ethernet1/1)#negotiation off
3.1.10 port-scan-mode
Command:
port-scan-mode {interrupt | poll}
no port-scan-mode