PLANET WGSW-50040 - Manual (Page 67)

deletes an User
Switch (config)#no snmp-server user tester
1.5 Commands for Switch Upgrade
1.5.1 copy（FTP）
Command:
copy <source-url> <destination-url> [ascii | binary]
Function:
Download files to the FTP client.
Parameter:
<source-url> is the location of the source files or directories to be copied; <destination-url> is the
destination address to which the files or directories to be copied; forms of <source-url> and
<destination-url> vary depending on different locations of the files or directories. ascii indicates
the ASCII standard will be adopted; binary indicates that the binary system will be adopted in the
file transmission（default transmission method）.When URL represents an FTP address, its form
should be:
ftp://<username>:<password>@{<ipaddress>|<ipv6address>|<hostname> }/<filename>,amongst
<username> is the FTP user name,<password> is the FTP user
password,<ipaddress>|<ipv6address> is the IPv4 or IPv6 address of the FTP
server/client,<hostname> is the name of the host mapping with the IPv6 address,it does not support
the file download and upload with hosts mapping with IPv4 addresses,<filename> is the name of the
FTP upload/download file.
Special keywords of the filename
Keywords Source or destination addresses
running-config Running configuration files
startup-config Startup configuration files
nos.img System files
nos.rom System startup files
Command Mode:
Admin Mode.
Usage Guide:
This command supports command line hints, namely if the user can enter commands in following
forms: copy <filename> ftp:// or copy ftp:// <filename> and press Enter, following hints will be
provided by the system：
ftp server ip/ipv6 address [x.x.x.x]/[x:x::x:x] >