PLANET WGSW-50040 - Manual (Page 403)

Global mode
Usage Guide:
This command is used to configure the source interfaces for the mirror. It is not restricted the source
interface of the mirror on the switch. The source can be one interface, or can be multiple interfaces.
Both of the income and outcome datagram can be mirrored, or they can be mirrored selectively. If
no [rx | tx | both] is specified, both are made to be the default. When multiple interfaces are mirrored,
the direction of the mirror can be different, but they should be configured separately.
Example:
Configure to mirror the datagram sent out by interface 1/1-4, and to mirror the datagram received by
interface 1/5.
Switch(config)#monitor session 1 source interface ethernet 1/1-4 tx
Switch(config)#monitor session 1 source interface ethernet 1/5 tx
29.2 monitor session source interface access-list
Command:
monitor session <session> source {interface <interface-list>} access-list <num> {rx | tx |
both}
no monitor session <session> source {interface <interface-list>} access-list <num>
Function:
Specify the access control for the source of the mirror. The no form command will disable this
configuration.
Parameters:
<session> is the session number for the mirror. Currently only 1 to 4 is supported.
<interface-list> is the list of source interfaces of the mirror which can be separated by “-“ and “;”.
<num> is the number of the access list.
rx means to filter the datagram received by the interface.
tx for the datagram sent out,
and both means both of income and outcome datagram.
Command Mode:
Global Mode.
Usage Guide:
This command is used to configure the source interfaces for the mirror. It is not restricted the source
interface of the mirror on the switch. The source can be one interface, or can be multiple interfaces.
For flow mirror, only datagram received can be mirrored. The parameters can be rx, tx, both. The