PLANET WGSW-50040 - Manual (Page 297)

Commands for Security Function Chapter 6 Commands for TACACS+
Usage Guide:
This command can only be configured on L2 general querier. The Suppression-query-time refers to
the period of suppression state in which the querier enters when receives query from the layer 3
IGMP in the segments.
Example
Switch(config)#ip igmp snooping vlan 2 suppression-query-time 270
18.2.19 show ip igmp snooping
Command:
show ip igmp snooping [vlan <vlan-id>]
Function:
Configure the suppression query time. The “no ip igmp snooping vlan <vlan-id>
suppression-query-time” command restores to the default value.
Parameter:
<vlan-id> is the VLAN number specified for displaying IGMP Snooping messages.
Command Mode:
Admin Mode
Usage Guide:
If no VLAN number is specified, it will show whether global IGMP Snooping switch is on, which
VLAN is configured with l2-general-querier function, and if a VLAN number is specified, detailed
IGMP messages for this VLAN will be shown.
Example
1. Show IGMP Snooping summary messages of the switch
Switch(config)#show ip igmp snooping
Global igmp snooping status: Enabled
L3 multicasting: running
Igmp snooping is turned on for vlan 1(querier)
Igmp snooping is turned on for vlan 2
--------------------------------
Displayed Information Explanation
Global igmp snooping status Whether the global igmp snooping switch on the switch is on
L3 multicasting whether the layer 3 multicast protocol of the switch is running
Igmp snooping is turned on for vlan
1(querier)
which VLANs on the switch is enabled with igmp snooping
function, whether they are l2-general-querier