7 mrpp enable, Mrpp enable – PLANET WGSW-50040 User Manual
Page 398
Command Mode:
MRPP ring mode
Default:
Default configuration timer interval is 1s.
Usage Guide:
The primary node of MRPP ring continuously sends Hello packet on configured Hello timer interval,
if secondary port of primary node can receive this packet in configured period; the whole loop is
normal, otherwise fail. Transfer node of MRPP ring doesn’t need this timer and configure.
Example:
Configure hello-timer of MRPP ring 4000 to 3 seconds.
Switch(config)# mrpp ring 4000
Switch(mrpp-ring-4000)#hello-timer 3
28.7 mrpp enable
Command:
mrpp enable
no mrpp enable
Function:
Enable MRPP protocol module, the “no mrpp enable” command disables MRPP protocol.
Command Mode:
Global Mode
Default:
The system doesn’t enable MRPP protocol module.
Usage Guide:
If it needs to configure MRPP ring, it enables MRPP protocol. Executing “no mrpp enable”
command, it ensures to disable the switch enabled MRPP ring.
Example:
Globally enable MRPP.
Switch(config)#mrpp enable