PLANET WGSW-50040 - Manual (Page 259)

Commands for Security Function Chapter 6 Commands for TACACS+
data of DHCP SNOOPING.
Command Mode:
Admin mode
Usage Guide:
This command is mainly used to debug the state of DHCP SNOOPING task when it adds ARP list
entries, dot1x users and trusted user list entries according to binding data.
16.6 ip dhcp snooping
Command:
ip dhcp snooping enable
no ip dhcp snooping enable
Function:
Enable the DHCP Snooping function.
Command Mode:
Globe mode.
Default Settings:
DHCP Snooping is disabled by default.
Usage Guide:
When this function is enabled, it will monitor all the DHCP Server packets of non-trusted ports.
Example:
Enable the DHCP Snooping function.
switch(config)#ip dhcp snooping enable
16.7 ip dhcp snooping binding
Command:
ip dhcp snooping binding enable
no ip dhcp snooping binding enable
Function:
Enable the DHCP Snooping binding funciton
Command Mode:
Globe mode
Default Settings: