PLANET WGSW-50040 - Manual (Page 226)

specified IP address.
Parameters:
<ip_address> is the IP address, at the same filed with interface address;
<mac_address> is the MAC address;
ethernet stands for Ethernet port;
<portName> for the name of layer2 port.
Default:
No static ARP entry is set by default.
Command mode:
VLAN Interface Mode
Usage Guide:
Static ARP entries can be configured in the switch.
Example:
Configuring static ARP for interface VLAN1.
Switch(Config-if-Vlan1)#arp 1.1.1.1 00-30-4f-f0-12-34 eth 1/2
12.3.2 clear arp-cache
Command:
clear arp-cache
Function:
Clears ARP table.
Command mode:
Admin Mode
Usage Guide:
Clears the content of current ARP table, but it does not clear the current static ARP table.
Example:
Switch#clear arp-cache
12.3.3 debug arp
Command:
debug arp {receive|send|state}
no debug arp {receive|send|state}
Function:
Enables the ARP debugging function; the “no debug arp {receive|send|state}” command disables