PLANET WGSW-50040 - Manual (Page 93)

1. Combo port is a conception involving the physical layer and the LLC sublayer of the
datalink layer. The status of a combo port will not affect any operation in the MAC
sublayer of the datalink layer and upper layers. If the bandwidth limit for a combo port
is 1Mbps, then this 1Mbps applies to the active port of this combo port, regardless of
the port type being copper or fiber.
2. If a combo port connects to another combo port, it is recommended for both parties to
use copper-forced or fiber-forced mode.
Run show interface under Admin Mode to check for the active port of a combo port .The
following result indicates if the active port for a combo port is the fiber cable port:
Hardware is Gigabit-combo, active is fiber.
Example:
Setting ports 1/21-24 to fiber-forced.
Switch(config)#interface ethernet 1/21-24
Switch(Config-Port-Range)#combo-forced-mode sfp-forced
3.1.3 clear counters interface
Command:
clear counters interface [{ethernet <interface-list> | vlan <vlan-id> | port-channel
<port-channel-number> | <interface-name>}]
Function:
Clears the statistics of the specified port.
Parameters:
<interface-list> stands for the Ethernet port number;
<vlan-id> stands for the VLAN interface number;
<port-channel-number> for trunk interface number;
<interface-name> for interface name, such as port-channel 1.
Command mode:
Admin Mode.
Default:
Port statistics are not cleared by default.
Usage Guide:
If no port is specified, then statistics of all ports will be cleared.
Example:
Clearing the statistics for Ethernet port1/1.
Switch#clear counters interface ethernet 1/1