PLANET WGSW-50040 - Manual (Page 363)

Commands for Security Function Chapter 6 Commands for TACACS+
23.3 mac-address query timeout
Command:
mac-address query timeout <seconds>
Function:
Set the timeout value of querying dynamic MAC.
Parameter:
<seconds> is timeout value, in second, ranging from 5 to 300.
Default Settings:
Default value is 60 seconds.
Command Mode:
Global mode
Usage Guide:
After enabling the number limitation of MAC, users can use this command to configure the timeout
value of querying dynamic MAC. If the data traffic is very large, the timeout value can be shorter,
otherwise, it can be longer. Users can set it according to actual situation.
Examples:
Set the timeout value of quering dynamic MAC as 30 seconds
Switch(config)# mac-address query timeout 30
23.4 show mac-address dynamic count
Command:
show mac-address dynamic count { (vlan <1-4096>)| interface ethernet <portName>}
Function:
Display the number of dynamic MAC of corresponding port and VLAN.
Parameters:
<vlan-id> display the specified VLAN ID.
<portName> is the name of layer-2 port.
Command Mode:
Any mode
Usage Guide:
Use this command to display the number of dynamic MAC of corresponding port and VLAN.
Examples:
Display the number of dynamic MAC of the port and VLAN which are configured with number
limitation function of MAC.