PLANET WGSW-50040 - Manual (Page 44)

Example:
Switch#terminal monitor
1.2.9 telnet
Command:
telnet {<ip-addr> | <ipv6-addr> | host <hostname>} [<port>]
Function:
Log on the remote host by Telnet
Parameter:
<ip-addr> is the IP address of the remote host, shown in dotted decimal notation;
<ipv6-addr> is the IPv6 address of the remote host;
<hostname> is the name of the remote host, containing max 30 characters;
<port> is the port number, ranging between 0~65535.
Command Mode:
Admin Mode.
Usage Guide:
This command is used when the switch is applied as Telnet client, for logging on remote host to
configure. When a switch is applied as a Telnet client, it can only establish one TCP connection with
the remote host. To connect to another remote host, the current TCP connection must be
disconnected with a hotkey “CTRL+ \”. To telnet a host name, mapping relationship between the
host name and the IP/IPv6 address should be previously configured. For required commands
please refer to ip host and ipv6 host. In case a host corresponds to both an IPv4 and an IPv6
addresses, the IPv6 should be preferred when telneting this host name.
Example:
The switch Telnets to a remote host whose IP address is 20.1.1.1.
Switch#telnet 20.1.1.1 23
Connecting Host 20.1.1.1 Port 23
Service port is 23
Connected to 20.1.1.1
login:123
password:***
WGSW-50040>