PLANET WGSW-50040 - Manual (Page 355)

Commands for Security Function Chapter 6 Commands for TACACS+
22.23 dot1x unicast enable
Command:
dot1x unicast enable
no dot1x unicast enable
Function:
Enable the 802.1x unicast passthrough function of switch; the no operation of this command will
disable this function.
Command mode:
Global Configuration Mode.
Default:
The 802.1x unicast passthrough function is not enabled in global mode.
Usage Guide:
The 802.1x unicast passthrough authentication for the switch must be enabled first to enable the
802.1x unicast passthrough function, then the 802.1x function is configured.
Example:
Enabling the 802.1x unicast passthrough function of the switch and enable the 802.1x for port 1/1.
Switch(config)#dot1x enable
Switch(config)# dot1x unicast enable
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#dot1x enable
22.24 dot1x web authentication enable
Command:
dot1x web authentication enable
no dot1x web authentication enable
Function:
Enable Web authentication agent, the no command disable Web authentication agent.
Default:
Web authentication agent is disabled.
Command mode:
Global Mode.
Usage Guide:
Dot1x function must be enabled before enabling Web authentication agent. When dot1x web
authentication agent is enabled, the dot1x privateclient enable command should not be
configured.