PLANET WGSW-50040 - Manual (Page 425)

Command mode:
Admin Mode
Usage Guide:
The show running-config command differs from show startup-config in that when the user
finishes a set of configurations, show running-config displays the added-on configurations whilst
show startup-config won’t display any configurations. However, if write command is executed to
save the active configuration to the Flash memory, the displays of show running-config and show
startup-config will be the same.
32.13 show switchport interface
Command:
show switchport interface [ethernet <IFNAME>]
Function:
Show the VLAN port mode, VLAN number and Trunk port messages of the VLAN port mode on the
switch.
Parameter:
<IFNAME> is the port number.
Command mode:
Admin mode
Example:
Show VLAN messages of port ethernet 1/1.
Switch#show switchport interface ethernet 1/1
Ethernet1/1
Type :Universal
Mac addr num : No limit
Mode :Access
Port VID :1
Trunk allowed Vlan :ALL
Displayed Information Description
Ethernet1/1 Corresponding interface number of the Ethernet.
Type Current interface type.
Mac addr num Number of interfaces with MAC address learning ability.
Mode :Access Current interface VLAN mode.