PLANET WGSW-50040 - Manual (Page 86)

No parameters means to display information of all member switches.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
Executing this command on a commander switch will display the configuration information of all
cluster member switches.
Example:
Execute this command on a commander switch to display the configuration information of all and
specified cluster member switches.
Switch#show cluster members
Member From : User config(U); Auto member (A)
ID From Status Mac Hostname Description Internal IP
--- - ----------- ----------------- ------------ ------------ ---------------
xxx x xxxxxxxxxx12 xx-xx-xx-xx-xx-xx xxxxxxxxxx12 xxxxxxxxxx12 xxx.xxx.xxx.xxx
1 U Inactive 00-01-02-03-04-05 MIS_zebra WGSW-50040 10.254.254.2
2 A Active 00-01-02-03-04-05 MIS_bison WGSW-50040 10.254.254.3
3 U Active 00-01-02-03-04-05 SRD_jaguar WGSW-50040 10.254.254.4
4 A Inactive 00-01-02-03-04-05 HRD_puma WGSW-50040 10.254.254.5
----
Switch#show cluster members id 1
Cluster Members:
ID: 1
Member status: Inactive member (user_config)
IP Address: 10.254.254.2
MAC Address: 00-01-02-03-04-06
Description: WGSW-50040
Hostname: 102
2.16 show cluster candidates
Command:
show cluster candidates [nodes-sn <candidate-sn-list> | mac-address <mac-addr>]
Function:
Display the statistic information of the candidate member switches on the command switch
Parameter:
candidate-sn-list：candidate switch sn, ranging from 1 to 256. More than one switch can be