PLANET WGSW-50040 - Manual (Page 349)

Commands for Security Function Chapter 6 Commands for TACACS+
22.14 dot1x max-user userbased
Command:
dot1x max-user userbased <number>
no dot1x max-user userbased
Function:
Set the upper limit of the number of users allowed access the specified port when using user-based
access control mode; the “no dot1x max-user userbased” command is used to reset the default
value.
Parameters:
<number> the maximum number of users allowed to access the network, ranging from 1 to 1~256.
Command Mode:
Port Mode.
Default Settings:
The maximum number of users allowed to access each port is 10 by default.
User Guide:
This command can only take effect when the port adopts user-based access control mode. If the
number of authenticated users exceeds the upper limit of the number of users allowed access the
network, those extra users can not access the network.
Examples:
Setting port 1/3 to allow 5 users.
Switch(Config-If-Ethernet1/3)#dot1x max-user userbased 5
22.15 dot1x port-control
Command:
dot1x port-control {auto|force-authorized|force-unauthorized }
no dot1x port-control
Function:
Sets the 802.1x authentication status; the “no dot1x port-control” command restores the default
setting.
Parameters:
auto enable 802.1x authentication, the port authorization status is determined by the authentication
information between the switch and the supplicant;
force-authorized sets port to authorized status, unauthenticated data is allowed to pass through
the port;
force-unauthorized will set the port to non-authorized mode, the switch will not provide