PLANET WGSW-50040 - Manual (Page 352)

Commands for Security Function Chapter 6 Commands for TACACS+
To force the authentication client to use private 802.1x authentication protocol.
Switch(config)#dot1x privateclient enable
22.18 dot1x re-authenticate
Command:
dot1x re-authenticate [interface <interface-name>]
Function:
Enables real-time 802.1x re-authentication (no wait timeout requires) for all ports or a specified port.
Parameters:
<interface-name> stands for port number, omitting the parameter for all ports.
Command mode:
Global Mode.
Usage Guide:
This command is an Global Mode command. It makes the switch to re-authenticate the client at
once without waiting for re-authentication timer timeout. This command is no longer valid after
authentication.
Example:
Enabling real-time re-authentication on port1/8.
Switch(config)#dot1x re-authenticate interface ethernet 1/8
22.19 dot1x re-authentication
Command:
dot1x re-authentication
no dot1x re-authentication
Function:
Enables periodical supplicant authentication; the “no dot1x re-authentication” command disables
this function.
Command mode:
Global Mode.
Default:
Periodical re-authentication is disabled by default.
Usage Guide: