PLANET WGSW-50040 - Manual (Page 389)

<retries> is a retransmission times for RADIUS server, the valid range is 0 to 100.
Command mode:
Global Mode
Default:
The default value is 3 times.
Usage Guide:
This command specifies the retransmission time for a packet without a RADIUS server response
after the switch sends the packet to the RADIUS server. If authentication information is missing from
the authentication server, AAA authentication request will need to be re-transmitted to the
authentication server. If AAA request retransmission count reaches the retransmission time
threshold without the server responding, the server will be considered to as not work, the switch
sets the server as invalid.
Example:
Setting the RADIUS authentication packet retransmission time to five times.
Switch(config)# radius-server retransmit 5
27.16 radius-server timeout
Command:
radius-server timeout <seconds>
no radius-server timeout
Function:
Configures the timeout timer for RADIUS server; the “no radius-server timeout” command
restores the default setting.
Parameters:
<seconds> is the timer value (second) for RADIUS server timeout, the valid range is 1 to 1000.
Command mode:
Global Mode
Default:
The default value is 3 seconds.
Usage Guide:
This command specifies the interval for the switch to wait RADIUS server response. The switch
waits for corresponding response packets after sending RADIUS Server request packets. If
RADIUS server response is not received in the specified waiting time, the switch resends the
request packet or sets the server as invalid according to the current conditions.