PLANET WGSW-50040 - Manual (Page 279)

Commands for Security Function Chapter 6 Commands for TACACS+
Switch(config)#access-list 5000 permit ip 10.1.1.0 0.0.0.255 232.0.0.0 0.0.0.255
18.1.3 ip multicast destination-control access-group
Command:
ip multicast destination-control access-group <6000-7999>
no ip multicast destination-control access-group <6000-7999>
Function:
Configure multicast destination-control access-list used on interface, the “no ip multicast
destination-control access-group <6000-7999>“ command deletes the configuration.
Parameter:
<6000-7999>: destination-control access-list number.
Command Mode:
Interface Configuration Mode
Usage Guide:
The command is only working under global multicast destination-control enabled, after configuring
the command, if IGMP-SPOOPING is enabled, for adding the interface to multicast group, and
match configured access-list, such as matching: permit, the interface can be added, otherwise do
not be added.
Example:
Switch(config)#inter e 1/4
Switch(Config-If-Ethernet 1/4)#ip multicast destination-control access-group 6000
Switch (Config-If-Ethernet1/4)#
18.1.4 ip multicast destination-control access-group
(sip)
Command:
ip multicast destination-control <IPADDRESS/M> access-group <6000-7999>
no ip multicast destination-control <IPADDRESS/M> access-group <6000-7999>
Function:
Configure multicast destination-control access-list used on specified net segment, the “no ip
multicast destination-control <IPADDRESS/M> access-group <6000-7999>“ command deletes
this configuration.
Parameter: