PLANET WGSW-50040 - Manual (Page 165)

9.1.14 spanning-tree mst configuration
Command:
spanning-tree mst configuration
no spanning-tree mst configuration
Function:
Enter the MSTP mode. Under the MSTP mode, the MSTP attributes can be set. The command “no
spanning-tree mst configuration” restores the attributes of the MSTP to their default values.
Command mode:
Global Mode
Default:
The default values of the attributes of the MSTP region are listed as below:
Attribute of MSTP Default Value
Instance There is only the instance 0. All the VLANs (1~4094) are mapped
to the instance 0.
Name MAC address of the bridge
Revision 0
Usage Guide:
Whether the switch is in the MSTP region mode or not, users can enter the MSTP mode, configure
the attributes, and save the configuration. When the switch is running in the MSTP mode, the
system will generate the MST configuration identifier according to the MSTP configuration. Only if
the switches with the same MST configuration identifier are considered as in the same MSTP
region.
Example:
Enter MSTP region mode.
Switch(config)#spanning-tree mst configuration
Switch(Config-Mstp-Region)#
9.1.15 spanning-tree mst cost
Command:
spanning-tree mst <instance-id> cost <cost>
no spanning-tree mst <instance-id> cost
Function:
Sets path cost of the current port in the specified instance; the command “no spanning-tree mst