PLANET WGSW-50040 - Manual (Page 330)

Commands for Security Function Chapter 6 Commands for TACACS+
32
21.19 permit | deny(ip standard)
Command:
{deny | permit} {{<sIpAddr> <sMask>} | any-source | {host-source <sIpAddr>}}
no {deny | permit} {{<sIpAddr> <sMask>} | any-source | {host-source <sIpAddr>}}
Functions:
Create a name standard IP access rule, and “no {deny | permit} {{<sIpAddr> <sMask>} |
any-source | {host-source <sIpAddr>}}” action of this command deletes this name standard IP
access rule.
Parameters:
<sIpAddr> is the source IP address, the format is dotted decimal notation;
<sMask > is the reverse mask of source IP, the format is dotted decimal notation.
Command Mode:
Name standard IP access-list configuration mode
Default:
No access-list configured.
Example:
Permit packets with source address 10.1.1.0/24 to pass, and deny other packets with source
address 10.1.1.0/16.
Switch(config)# access-list ip standard ipFlow
Switch(Config-Std-Nacl-ipFlow)# permit 10.1.1.0 0.0.0.255
Switch(Config-Std-Nacl-ipFlow)# deny 10.1.1.0 0.0.255.255
21.20 permit | deny(ipv6 standard)
Command:
[no] {deny | permit} {{<sIPv6Prefix/sPrefixlen>} | any-source | {host-source <sIPv6Addr>}}
Function:
Create a standard nomenclature IPv6 access control rule; the “no” form of this command deletes
the nomenclature standard IPv6 access control rule.
Parameter:
<sIPv6Prefix> is the prefix of the source IPv6 address,