PLANET WGSW-50040 - Manual (Page 288)

Commands for Security Function Chapter 6 Commands for TACACS+
data packet message can be shown with “packet” parameter, event message with “event”, timer
message with “time”, downsending hardware entries message with “mfc”, and all debugging
messages with “all”.
18.2.4 ip igmp snooping
Command:
ip igmp snooping
no ip igmp snooping
Function:
Enable the IGMP Snooping function; the “no ip igmp snooping” command disables this function.
Command Mode:
Global Mode
Usage Guide:
Use this command to enable IGMP Snooping, that is permission every VLAN config the function of
IGMP snooping. The “no ip igmp snooping” command disables this function.
Example:
Enable IGMP Snooping.
Switch(config)#ip igmp snooping
18.2.5 ip igmp snooping vlan
Command:
ip igmp snooping vlan <vlan-id>
no ip igmp snooping vlan <vlan-id>
Function:
Enable the IGMP Snooping function for the specified VLAN; the “no ip igmp snooping vlan
<vlan-id>“ command disables the IGMP Snooping function for the specified VLAN.
Parameter:
<vlan-id> is the VLAN number.
Command Mode:
Global Mode
Usage Guide:
To configure IGMP Snooping on specified VLAN, the global IGMP Snooping should be first enabled.
Disable IGMP Snooping on specified VLAN with the “no ip igmp snooping vlan <vlan-id>”
command.