PLANET WGSW-50040 - Manual (Page 422)

32.8 show history
Command:
show history
Function:
Display the recent user command history.
Command mode:
Admin Mode
Usage Guide:
The system holds up to 20 commands the user entered, the user can use the UP/DOWN key or
their equivalent (ctrl+p and ctrl+n) to access the command history.
Example:
Switch#show history
enable
config
interface ethernet 1/3
enable
dir
show ftp
32.9 show logging buffered
Command:
show logging buffered [level {critical | warnings} | range <begin-index> <end-index>]
Function:
This command displays the detailed information in the log buffer channel. This command is not
supported on low end switches.
Parameter:
level {critical | warnings} means the level of critical information.
<begin-index> is the index start value of the log message, the valid range is 1-65535,
<end-index> is the index end value of the log message, the valid range is 1-65535. When only
display logging buffered information of the line card must be added range parameter, but the main
control has not the request.
Command Mode:
Admin and Configuration Mode.
Default: