PLANET WGSW-50040 - Manual (Page 245)

Commands for Security Function Chapter 6 Commands for TACACS+
Switch(dhcp-1-config)#hardware-address 00-00-e2-3a-26-04
Switch(dhcp-1-config)#host 10.1.128.160 24
Related Command:
Host
15.1.11 host
Command:
host <address> [<mask> | <prefix-length> ]
no host
Function:
Specifies the IP address to be assigned to the user when binding addresses manually; the “no
host” command deletes the IP address.
Parameters:
<address> is the IP address in decimal format;
<mask> is the subnet mask in decimal format;
<prefix-length> means mask is indicated by prefix. For example, mask 255.255.255.0 in prefix is
“24”, and mask 255.255.255.252 in prefix is “30”.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
If no mask or prefix is configured when configuring the IP address, and no information in the IP
address pool indicates anything about the mask, the system will assign a mask automatically
according to the IP address class.
This command is used with “hardware address” command or “client identifier” command when
binding addresses manually. If the identifier or hardware address of the requesting client matches
the specified identifier or hardware address, the DHCP server assigns the IP address defined in
“host” command to the client.
Example:
Specifying IP address 10.1.128.160 to be bound to user with hardware address 00-10-5a-60-af-12
in manual address binding.
Switch(dhcp-1-config)#hardware-address 00-10-5a-60-af-12
Switch(dhcp-1-config)#host 10.1.128.160 24
Related command:
hardware-address, client-identifier