PLANET WGSW-50040 - Manual (Page 119)

Chapter 7 VLAN
Configuration
7.1 Commands for VLAN Configuration
7.1.1 debug gvrp
Command:
debug gvrp
no debug gvrp
Function:
Enable the GVRP debugging function: the “no debug gvrp” command disables the function.
Command mode:
Admin Mode.
Default:
GVRP debug information is disabled by default.
Usage Guide:
Use this command to enable GVRP debugging, GVRP packet processing information can be
displayed.
Example:
Enable GVRP debugging.
Switch#debug gvrp
7.1.2 dot1q-tunnel enable
Command:
dot1q-tunnel enable
no dot1q-tunnel enable
Function:
Set the access port of the switch to dot1q-tunnel mode; the “no dot1q-tunnel enable” command
restores to default.
Parameter:
None.
Command Mode: