PLANET WGSW-50040 - Manual (Page 81)

Switch(config)#cluster member auto-to-user
2.9 cluster reset member
Command:
cluster reset member [id <member-id> | mac-address <mac-addr>]
Function:
In the commander switch, this command can be used to reset the member switch.
Parameter:
member-id: ranging from 1 to 128. Use hyphen “-” or semicolon “;” to specify more than one
member; if no value is provided, it means to reboot all member switches.
Default:
Boot all member switches.
Command mode:
Admin Mode.
Instructions:
In the commander switch, users can use this command to reset a member switch. If this command
is executed in a non-commander switch, an error will be displayed.
Example:
In the commander switch, reset the member switch 1.
Switch#cluster reset member 1
2.10 cluster run
Command:
cluster run [key <WORD>][ vid <VID>]
no cluster run
Function:
Enable cluster function; the “no cluster run” command disables cluster function.
Parameter:
key：all keys in one cluster should be the same, no longer than 16 characters.
vid：vlan id of the cluster, whose range is 1-4094.
Command mode:
Global Mode
Default:
Cluster function is disabled by default, key: NULL(\0) vid：1.