PLANET WGSW-50040 - Manual (Page 185)

10.8 mls qos queue algorithm
Command:
mls qos queue algorithm {sp | wrr | wdrr}
no mls qos queue algorithm
Function:
After configure this command, the queue management algorithm is set.
Parameters:
sp: The strict priority, the queue number of bigger, then the priority is higher.
wrr: Select wrr algorithm
wdrr: Select wdrr algorithm
Default:
The default queue algorithm is wrr.
Command mode:
Port Mode
Usage Guide:
After configure this command, the queue management algorithm is set.
Example:
Setting the queue management algorithm as wrr.
Switch(interface-ethernet1/1/1)#mls qos queue algorithm wrr
10.9 mls qos queue wrr weight
Command:
mls qos queue wrr weight <weight0..weight7>
no mls qos queue wrr weight
Function:
After configure this command, the queue weight is set.
Parameters:
<weight0..weight7> defines the queue weight, for WRR algorithm, this configuration is valid, for SP
algorithm, this configuration is invalid, when the weight is 0, this queue adopts SP algorithm to
manage, and WRR algorithm turns into SP+WRR algorithm. The absolute value of WRR is
meaningless. WRR allocates bandwidth by using 8 weight values. The different chips support the
different weight range, if the setting exceeds the chip range will prompt the right range, when the