PLANET WGSW-50040 - Manual (Page 402)

Command Mode:
Admin and Configuration Mode.
Example:
Display statistic information of MRPP ring 4000 of switch.
Switch# show mrpp statistic 4000
Chapter 29 Commands for
Mirroring Configuration
29.1 monitor session source interface
Command:
monitor session <session> source {interface <interface-list> | cpu [slot <slotnum> ]} {rx| tx|
both}
no monitor session <session> source {interface <interface-list> | cpu [slot <slotnum> ]}
Function:
Specify the source interface for the mirror. The no form command will disable this configuration.
Parameters:
<session> is the session number for the mirror. Currently only 1 to 4 is supported.
<interface-list> is the list of source interfaces of the mirror which can be separated by “-“ and “;”.
cpu means the CPU on the board to be the source of the mirror for debugging. Datagram received
by or sent by the CPU. Currently the CPU mirror is only supported be configured in session 4.
rx means to filter the datagram received by the interface,
while tx for the datagram sent out,
and both means both of income and outcome datagram.
Command mode: