2 sntp server, Sntp server – PLANET WGSW-50040 User Manual
Page 412
select for SNTP clock selection.
Command mode:
Admin Mode
Example:
Displaying debugging information for SNTP packet.
Switch#debug sntp packet
31.2 sntp server
Command:
sntp server {<server_address> | <server_ipv6_addr>} [version <version_no>]
no sntp server { <server_address> | <server_ipv6_addr> }
Function:
Configure the IPv4/IPv6 addresses and the version of the SNTP/NTP server; the “no” form of this
command cancels the configured SNTP/NTP server addresses.
Parameter:
<server_address> is the IPv4 unicast address of the SNTP/NTP server,
<server_ipv6_addr> is the IPv6 unicast address of the SNTP/NTP server,
<version_no> is the version No. of the SNTP on current server, ranging between 1-4 and defaulted
at 1.
Default:
No SNTP/NTP configured by default.
Command Mode:
Global Mode
Example:
(1) Configure an IPv4 address of a SNTP/NTP server. SNTPv4 version is adopted on the server
Switch(config)#sntp server 10.1.1.1 version 4
(2) Configure a SNTP/NTP server IPv6 address
Switch(config)#sntp server 3ffe:506:1:2::5