PLANET WGSW-50040 - Manual (Page 347)

Commands for Security Function Chapter 6 Commands for TACACS+
22.11 dot1x max-req
Command:
dot1x max-req <count>
no dot1x max-req
Function:
Sets the number of EAP request/MD5 frame to be sent before the switch re-initials authentication on
no supplicant response; the “no dot1x max-req” command restores the default setting.
Parameters:
<count> is the times to re-transfer EAP request/ MD5 frames, the valid range is 1 to 10.
Command mode:
Global Mode.
Default:
The default maximum for retransmission is 2.
Usage Guide:
The default value is recommended in setting the EAP request/ MD5 retransmission times.
Example:
Changing the maximum retransmission times for EAP request/ MD5 frames to 5 times.
Switch(config)#dot1x max-req 5
22.12 dot1x user free-resource
Command:
dot1x user free-resource <prefix> <mask>
no dot1x user free-resource
Function:
To configure 802.1x free resource; the no form command closes this function.
Parameter:
<prefix> is the segment for limited resource，in dotted decimal format;
<mask> is the mask for limited resource，in dotted decimal format.
Command Mode:
Global Mode.
Default:
There is no free resource by default.
Usage Guide:
This command is available only if user based access control is applied. If user based access control
has been applied, this command configures the limited resources which can be accessed by the