INFICON IC/5 Thin Film Deposition Controller - Manual (Page 132)

6 - 12
IP
N 07
4-
23
7A
E
IC/5 Operating Manual
6.4 ’THEN’ Action Definitions
NOTE: The following are level outputs and once turned on will remain active until
turned off. This is true even if the Logic string is cleared.
START INHIBIT (ON/OFF) CRYSTAL FAIL INHIBIT (ON/OFF)
RW HOLD (ON/OFF) RW HOLD INHIBIT (ON/OFF)
SOAK HOLD 1 (ON/OFF) ### SOAK HOLD 2 (ON/OFF) ###
EXTERNAL OUTPUT (ON/OFF) ## MESSAGE (ON/OFF) ##
NON-DEPOSIT CLOCK HOLD (ON/OFF)
CANCEL TIMER #
Deactivates the designated timer to restore its status to ’Not Active’ and ’Not
Expired’.
COUNT ### ###
Sets the designated counter to the value programmed in ###. The first field,
###, designates the counter number. The second field, ###, designates the
number of counts. Up to 20 counters may be set.
CRYSTAL FAIL INHIBIT (ON/OFF)
This Action prohibits the Crystal Fail state from becoming active. This is useful
when changing crystals.
DECREMENT COUNTER #
Decreases the count by one (if nonzero) in the designated counter.
EXTERNAL OUTPUT (ON/OFF) #
Designates a hardware output and places it into its ON or OFF state. Outputs
can be given names up to 10 characters long. Outputs are named in the I/O
Map display, see
section 6.6 on page 6-16 .
MESSAGE (ON/OFF) #
Designates the user-defined message indicated and displays the message on
the CRT (or removes it from being displayed). The message is displayed on the
Operate Screen in the error message section of the display (the lower right
hand corner of the CRT display). Messages are defined in the User Message
display. (See
section 6.7 on page 6-17 .)