INFICON IC/5 Thin Film Deposition Controller - Manual (Page 136)

6 - 16
IP
N 07
4-
23
7A
E
IC/5 Operating Manual
6.6 I/O Map Directory
The I/O Map directory is selected by pressing the F3 key (I/O) in the Program
display and then the F2 key (I/O MAP Directory). From the I/O Map directory, the
desired I/O Board is chosen with the box cursor. Pressing the F5 key (I/O MAP)
enters the I/O Map display for the designated board. The I/O Map display for board
1 is shown in
Figure 6-5 . Upon entry the cursor will be placed at the last referenced
output or input number.
Figure 6-5 /O Map Board 1
Table 6-3 Function Key Selection Choices for the I/O Map Display
Key Function Description
F1 EDIT NAME Pressing this key will display a series of 10
underscores representing ten positions. The
left and right arrow keys are used to move
back and forth among the 10 positions. The up
and down arrow keys are used to scroll
through an alphanumeric listing, A through Z,
0 through 9, and the following characters: !, #,
±, %, & and -. Once the desired character is
displayed, pressing the E key enters the
character and advances the reverse video
cursor box to the next position.
F2 SAVE NAME Pressing this key saves the Name of the Input
or Output. Once saved, this Name will be
displayed whenever this Output (or Input) is
chosen in the Edit Logic Statement Display.
F3 CANCEL NAME CHANGE Pressing this key cancels any changes to the
Name made after pressing the F1 KEY (EDIT
NAME).