7 define user messages – INFICON IC/5 Thin Film Deposition Controller User Manual
Page 137
6 - 17
IP
N 07
4-
23
7A
E
IC/5 Operating Manual
6.7 Define User Messages
Up to 10 user-defined messages can be created and up to 3 can be displayed at
the same time. The messages are displayed in the lower right hand corner of the
CRT. The messages are turned on and off with the Logic Statements using the
MESSAGE ON/OFF Actions. If required to display IC/5 generated messages,
these user-defined messages will be overwritten.
The User Messages display is entered by pressing the F3 key (I/O) panel from the
Program display and then pressing F3 (DEFINE USER MESSAGES).
Figure 6-6 Define User Messages
F4
CLEAR NAME
Pressing this key clears the Name associated
with the designated output (or input).
F5
TOGGLE TYPE
Pressing this key toggles the relay type from
Normally Open (NO) to Normally Closed (NC).
F6
I/O MAP DIRECTORY
Pressing this key returns the display to the I/O
Map Directory.
Table 6-3 Function Key Selection Choices for the I/O Map Display
Key Function
Description