INFICON IC/5 Thin Film Deposition Controller - Manual (Page 291)

13 - 27
IP
N 07
4-
23
7A
E
IC/5 Operating Manual
13.3.5 Crystal Snatcher
Use the crystal snatcher, supplied with the sensor, as follows:
1 Insert crystal snatcher into ceramic retainer (1) and apply a small amount of
pressure. This locks the retainer to the snatcher and allows the retainer to be
pulled straight out (2).
2 Reinsert the retainer into the holder after the crystal has been replaced.
3 Release the crystal snatcher with a slight side-to-side motion.
Figure 13-4 Use of the Crystal Snatcher
13.3.6 CrystalSix
Refer to the Crystal Six Operating Manual (IPN 074-155) for specific instructions
for this device.