Start up, Start-up check list, Prepare for initial drive start-up – Rockwell Automation 21G PowerFlex 750-Series AC Drives Programming Manual User Manual
Page 15: Chapter 1, Chapter
Rockwell Automation Publication 750-PM001J-EN-P - October 2014
15
Chapter
1
Start Up
This chapter provides the information needed to start up the PowerFlex
750-Series drive.
Start-Up Check List
•
This check list supports the Start-Up menu option.
•
A Human Interface Module (HIM) is required to run the Start-Up
routine.
For detailed information on using the HIM, refer to the Enhanced
PowerFlex 7-Class Human Interface Module (HIM) User Manual,
publication 20HIM-UM001.
•
The Start-Up routine may modify parameter values for Analog and Digital
I/O.
Prepare For Initial Drive Start-Up
❏
1.
Confirm that drive has been installed according to the PowerFlex 750-
Series AC Drives Installation Instructions, publicat
.
❏
2.
Confirm that all inputs are connected to the correct terminals and are
secure.
❏
3.
Verify that AC line power at the disconnect device is within the rated value
of the drive.
❏
4.
Verify that control power voltage is correct.
Topic
Page
Establishing A Connection With EtherNet/IP
ATTENTION: Power must be applied to the drive to perform the following start-up
procedure. Some of the voltages present are at incoming line potential. To avoid electric
shock hazard or damage to equipment, only qualified service personnel should perform
the following procedure. Thoroughly read and understand the procedure before
beginning.