Rockwell Automation 21G PowerFlex 750-Series AC Drives Programming Manual - Manual (Page 212)

212 Rockwell Automation Publication 750-PM001J-EN-P - October 2014
Chapter 3 Drive Port 0 Parameters
Drive (Port 0) General
Purpose Parameters
Fi
le
Gr
ou
p
No. Display Name
Full Name
Description Values
Re
ad
-Write
Da
ta T
ype
964 CRC Flt Cfg
CRC Fault Configuration
Allows the user to configure exception 917 [FPGA CRC Failure] and change the
default state.
Ignore (0) – No action is taken.
Alarm (1) – Type 1 alarm indicated.
Flt Minor (2) – Minor fault indicated. If running, drive continues to run.
Enable with P950 [Minor Flt Cfg]. If not enabled, acts like a major fault.
FltCoastStop (3) – Major fault indicated. Coast to Stop.
Flt RampStop (4) – Major fault indicated. Ramp to Stop.
Flt CL Stop (5) – Major fault indicated. Current Limit Stop.
FltNonReset (6) – Major fault indicated. Cycle power to clear this fault.
Default:
Options: 6 - FltNonReset
0 - Ignore
1 - Alarm
2 - Fit Minor
3 - FltCoastStop
4 - Flt RampStop
5 - Flt CL Stop
6 - FltNonReset RW 32-bit
Integer
1700…1731 UserData Int 00…31
User Data Integer 00…31
Available for storage of a 32-bit integer values by the user.
Default:
Min/Max: 0
-2147483647 / 2147483647 RW 32-bit
Integer
1800…1831 UserData Real 00…31
User Data Real 00…31
Available for storage of a real values by the user.
Default:
Min/Max: 0.0000
-2147483647 / 2147483647 RW Float
1900
1904
1908
1912
1916
1920
1924
1928 ScaleBlk Sel 00
ScaleBlk Sel 01
ScaleBlk Sel 02
ScaleBlk Sel 03
ScaleBlk Sel 04
ScaleBlk Sel 05
ScaleBlk Sel 06
ScaleBlk Sel 07
Scale Block Select n
Selects the source value to be scaled. Default:
Min/Max: Disabled
0 / 159999 RW 32-bit
Integer
1901
1905
1909
1913
1917
1921
1925
1929 ScaleBlk Scal 00
ScaleBlk Scal 01
ScaleBlk Scal 02
ScaleBlk Scal 03
ScaleBlk Scal 04
ScaleBlk Scal 05
ScaleBlk Scal 06
ScaleBlk Scal 07
Scale Block Scale n
Scales (multiplier) the selected parameter value. Default:
Min/Max: 1.0000
-2147483647 / 2147483647 RW Float
1902
1906
1910
1914
1918
1922
1926
1930 ScaleBlk Int 00
ScaleBlk Int 01
ScaleBlk Int 02
ScaleBlk Int 03
ScaleBlk Int 04
ScaleBlk Int 05
ScaleBlk Int 06
ScaleBlk Int 07
Scale Block Integer n
Displays the scaling result as a 32-bit integer value. Default:
Min/Max: 0
-2147483647 / 2147483647 RO 32-bit
Integer
753