Rockwell Automation 21G PowerFlex 750-Series AC Drives Programming Manual - Manual (Page 91)

Rockwell Automation Publication 750-PM001J-EN-P - October 2014 91
Drive Port 0 Parameters Chapter 3
DR
IV
E C
FG
Sta
rt
F
ea
tur
es
350 Sleep Wake Mode
Sleep Wake Mode
Enables/disables the Sleep/Wake function.
Important: When enabled, the following conditions must be met:
• A proper value must be programmed for 352 [Sleep Level] and 354 [Wake Level].
• A sleep / wake reference must be selected in 351 [SleepWake RefSel].
• At least one of the following must be programmed (and input closed) in P155 [DI
Enable], P158 [DI Stop], P163 [DI Run], P164 [DI Run Forward], or P165 [DI Run
Reverse].
Default:
Options: 0 = “Disabled”
0 = “Disabled”
1 = “Direct” (Enabled)
2 = “Invert” (Enabled)
(7)
RW 32-bit
Integer
Fi
le
Grou
p
No. Display Name
Full Name
Description Values
Re
ad
-W
ri
te
Da
ta
T
ype
ATTENTION: Enabling the Sleep/Wake function can cause unexpected machine operation during the Wake mode.
Equipment damage and/or personal injury can result if this parameter is used in an inappropriate application. Do Not use
this function without considering the information below. In addition, all applicable local, national, and international
codes, standards, regulations, or industry guidelines must be considered.
Conditions Required to Start Drive
(1) (2) (3)
(1) When power is cycled, if all conditions are present after power is restored, restart will occur.
(2) If all conditions are present when [Sleep-Wake Mode] is “enabled,” the drive will start.
(3) The active speed reference. The Sleep/Wake function and the speed reference may be assigned to the same input.
Input After Power-Up After a Drive Fault After a Stop Command
Reset by HIM
or Software “Stop” Reset by HIM, Network/Software, or
Digital Input “Clear Faults” HIM, Network/Software or Digital Input
“Stop”
Stop
(4)
(4) Cannot use P159 [DI Cur Lmt Stop] or P160 [DI Coast Stop] as the only Stop Input. This will cause the drive to go into a Sleep Cfg Alarm - Event No. 161.
Stop Closed
Wake Signal
New Start or Run Cmd.
(5)
(5) Command must be issued from HIM, terminal block, or network.
Stop Closed
Wake Signal
New Start or Run Cmd.
(5)
Stop Closed
Wake Signal Stop Closed
Direct Mode:
SleepWake RefSel Signal > Sleep Level
(7)
Invert Mode:
SleepWake RefSel Signal < Sleep Level
(8)
New Start or Run Command
(5)
(7) SleepWake Ref Sel signal does not need to be greater than the wake level.
(8) SleepWake Ref Sel signal does not need to be less than the wake level.
Enable Enable Closed
Wake Signal Enable Closed
Wake Signal
New Start or Run Cmd.
(5)
Enable Closed
Wake Signal Enable Closed
Direct Mode:
SleepWake RefSel Signal > Sleep Level
(7)
Invert Mode:
SleepWake RefSel Signal < Sleep Level
(8)
New Start or Run Command (5)
Run
Run Fwd
Run Rev Run Closed
Wake Signal New Run Cmd.
(6)
Wake Signal
(6) Run Command must be cycled.
Run Closed
Wake Signal New Run Command
Direct Mode:
SleepWake RefSel Signal > Sleep Level
(7)
Invert Mode:
SleepWake RefSel Signal < Sleep Level
(8)