Rockwell Automation 21G PowerFlex 750-Series AC Drives Programming Manual - Manual (Page 151)

Rockwell Automation Publication 750-PM001J-EN-P - October 2014 151
Drive Port 0 Parameters Chapter 3
Fil
e
Gr
ou
p
No. Display Name
Full Name
Description Values
Re
ad
-Write
Da
ta T
ype
CO
MMUNIC
AT
ION
D
P
I Da
tali
nks
Important: DPI Datalinks parameters are used for datalinks on legacy 20-COMM-n
communication devices. For embedded EtherNet/IP or 20-750 option datalinks, refer to
the parameters associated with the specific option module.
895
896 Data In A1
Data In A2
Data Input An
Parameter number whose value will be written from a communications device data
table. Default:
Min/Max: 0 (0 = “Disabled”)
0 / 159999 RW 32-bit
Integer
897
898 Data In B1
Data In B2
Data Input Bn
Parameter number whose value will be written from a communications device data
table. See [Data In A1].
899
900 Data In C1
Data In C2
Data Input Cn
Parameter number whose value will be written from a communications device data
table. See [Data In A1].
901
902 Data In D1
Data In D2
Data Input Dn
Parameter number whose value will be written from a communications device data
table. See [Data In A1].
905
906 Data Out A1
Data Out A2
Data Output An
Parameter number whose value will be written to a communications device data table. Default:
Min/Max: 0 (0 = “Disabled”)
0 / 159999 RW 32-bit
Integer
907
908 Data Out B1
Data Out B2
Data Output Bn
Parameter number whose value will be written from a communications device data
table. See [Data Out A1].
909
910 Data Out C1
Data Out C2
Data Output Cn
Parameter number whose value will be written from a communications device data
table. See [Data Out A1].
911
912 Data Out D1
Data Out D2
Data Output Dn
Parameter number whose value will be written from a communications device data
table. See [Data Out A1].