Yaskawa SGDS Sigma III Servo Amplifier - Manual (Page 127)

5 Wiring
5.6.5 AC/DC Reactor for Harmonic Suppression
5-24
5.6.5 AC/DC Reactor for Harmonic Suppression
(1) Reactor Types
The SERVOPACK has reactor connection terminals for power supply harmonic suppression. The type of reactor
to be connected differs depending on the SERVOPACK capacity. Refer to the following table.
Note: Select a proper AC or DC reactor for the input current to the SERVOPACK.
Refer to 2.5.2 Molded-case Circuit Breaker and Fuse Capacity for input current to each
SERVOPACK. For the kind of reactor, refer to 4.4.9 AC/DC Reactors for Power Supplied
Designed for Minimum Harmonics.
(2) Connecting a Reactor
Connect a reactor as shown in the following diagram.
Note: 1. The DC reactor’s 1 and 2 terminals are short-circuited before shipment. Remove the lead
wire between these two terminals and connect the DC reactor.
2. AC/DC reactor is an option.
Applicable
SERVOPACK Model
SGDS-
AC/DC Reactor
Model
Reactor Specifications
Impedance
(mH)
Rated
Current
(A)
Single-phase,
100 V
A5F X5053
20.0 2.0
01F X5053
02F X5054 5.0 3.0
04F X5056 2.0 5.0
Single-phase,
200 V
A5A X5052
45.0 1.0
01A X5052
02A X5053 20.0 2.0
04A X5054 5.0 3.0
08A X5056 2.0 5.0
Three-phase,
200 V
10A X5061 2.0 4.8
15A
Consult Factory Consult Factory Consult
Factory
20A
Consult Factory Consult Factory Consult
Factory
30A
Consult Factory Consult Factory Consult
Factory
AC Reactor DC Reactor
SERVOPACK
L1
L2
AC reactor Power supply
Single-phase Input
1
2
DC reactor
Three-phase Input
SERVOPACK