Yaskawa MEMOCON GL120 - Manual (Page 361)

Installation and Wiring
5.1.3 Preventing Electrical Noise cont.
— 5-4 —
(a) The device mounting steel plate on which the Mounting Base is to be installed
must have integral (one-piece) structure.
(b) If the device mounting steel plate is coated, always peel off the coating round
each mounting bolt hole before installing the Mounting Base. Also pay atten-
tion to mounting screws to ensure conductivity between the Mounting Base
and the device mounting steel plate.
(5) Note the following when installing the Mounting Base on a DIN track.
• When installing the Power Supply Module on the Mounting Base, connect the protec-
tive ground terminal (FG) of the Power Supply Module to the module mounting screw
with a 2.0 mm
2 wire.
Connect the protective ground terminal (FG) to the
module mounting screw with a 2.0 mm 2 wire.
DIN track
Mounting Base
Power Supply Module
5