Yaskawa MEMOCON GL120 - Manual (Page 392)

!
!
5.2 Installing Mounting Bases and Modules
— 5-35 —
5.2.5 Connector for Field Connections Module
1) This section shows how to install and remove the following Module.
(1) 12/24 VDC 32 points I/O Module
(2) 12/24 VDC 64 points I/O Module
(3) Special Purpose Module with the connector for field connection
2) Installing Modules
Caution Do not remove the connector covers from the Module connectors on the Mounting Base slots
where no Modules are installed.
The GL120 and GL130 may malfunction if any foreign matter enters a Module connector.
Caution Make sure that all mounting screws for the Modules are securely tightened.
Make sure that all mounting screws for the Modules are securely tightened so that they
do not become loose. Loose screws may cause malfunction of the GL120 and GL130.
Install the connector for Field Connection Module on the Mounting Base. Use the follow-
ing procedures to install the Module.
1) Remove the cover from the Module connector on the Mounting Base.
Module hook
Module connector
2) Install the Module on the Mounting Base as shown below.
a) Hook the PS10 Module to the Module hook on the Mounting Base.
Module hook
Module
connector
Mounting Base
DC24IN-32P
5