Yaskawa MEMOCON GL120 - Manual (Page 457)

6.2 I/O Modules
— 6-19 —
4) 100-to 120-VAC or 200-to 240-VAC 8-point Output Module
Table 6.7 Specifications of the 100-to 120-VAC or 200-to 240-VAC 8-point Output Module
Item Specification
Name 100- to 120-VAC or 200- to 240-VAC 8-point Output Module
Model Name ACOUT-8P
Model No. JAMSC-120DAO83009 (EN Standards)
Rated Voltage 100 to 120 VAC or 200 to 240 VAC
Allowable Voltage Range 80 to 264 VAC
Rated Frequency 50/60 Hz
Allowable Frequency Range 47 to 63 Hz
Maximum Load Current 1.0 A rms/point
Output Voltage Drop 1.0 V rms
Output Delay Times OFF to ON: 5 ms max.
ON to OFF: 1/2 cycle + 5 ms max.
OFF Leakage Current 3 mA max. at 240 VAC, 50 Hz
Minimum Load Current 10 mA rms
Output Type Triac outputs
Number of Commons 8 (Each output circuit is independent.)
Output Power Supply per Common Possible to connect different power supply phases to the
commons.
External Connections Removable terminal block with M3 screw terminals
Output Protection Type Unprotected outputs (according to IEC 1131-2)
Built-in Fuse None
Surge Suppressor Varistor
Other Output Protection None
Number of Outputs 8
Output Signal Indication Indicator for each point; lit when output is ON.
Status saved in internal logic.
Status Indication ACTIVE: Lights during output processing
Insulation Method Phototriac
Dielectric Strength 1,500 VAC for 1 min or 1,800 VAC for 1 s between output
terminals and internal circuits and between all output circuit.
Insulation Resistance 100 MΩ min. (room temperature and humidity) between
output terminals and ground (via 500-VDC insulation
resistance meter)
External Power Supply 100 to 120 VAC or 200 to 240 VAC supplied to drive loads
Derating Conditions None
Internal Current Consumption 150 mA at 5 VDC (with all points ON)
Maximum Heating Value 9.0 W
Hot Swapping
(Removal/Insertion Under Power)
Permitted
Approximate Mass 300 g
External Dimensions 40.3 x 130 x 103.9 mm (W x H x D)
6