Yaskawa MEMOCON GL120 - Manual (Page 423)

Installation and Wiring
5.3.3 Wiring Digital I/O Modules cont.
— 5-66 —
7) When using an insulation transformer for the primary side of DC voltage stabilizing power
supply, always make sure to separate the primary and the secondary coils. When using a
noise filter, also be sure to separate the primary and the secondary coils.
C. 64-point Digital I/O Module
1) There are 2 64-point Digital I/O Modules with connectors for external connections.
a) 12/24-VDC 64-point Input Module (Model No.: JAMSC-120DDI36400)
b) 12/24-VDC 64-point Output Module (Model No.: JAMSC-120DDO36410)
2) Use the following cables for the I/O signal wire to connect to the I/O Modules.
a) I/O signal cables manufactured by the customer
b) 64-point I/O Module cables W5410 manufactured by Yaskawa
3) Use the following electric cables and connectors to manufacture I/O signal cables to con-
nect to these Digital I/O Modules.
a) Cable size: 0.26 mm 2 (AWG23)
b) Module connector (provided as accessory)
• Connector: FCN-361J040-AU (soldered) (Fujitsu)
• Cover: FCN-360C040-B (Fujitsu)
4) When an W5410 64-point I/O Module Cable is used, select the appropriate cable from
the 4 cables shown in the following table:
Table 5.15 W5410 64-point I/O Module Cables
Item Specifications
Name W5410 Cable
Model Name W5410-05 W5410-10 W5410-30
Model No. JEPMC-W5410-05 JEPMC-W5410-10 JEPMC-W5410-30
Length (L) 0.5 m 1.0 m 3.0 m
Cable Specifications Shielded cable of 40 conductors, corresponding to AWG24 (0.20 mm 2 )
Terminals Module side Connector fitted: FCN-363J-040 (FUJITSU LTD.)
FCN-360C040-B (FUJITSU LTD.)
FCN-363J-AU/R (FUJITSU LTD.)
External
device side Loose wires: Wire length 100 mm with pin number label on each wire.
5