15 list current calls - +clcc – Rainbow Electronics GM862-QUAD-PY User Manual
Page 106
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 106 of 434
+CAOC - Advice Of Charge
SELINT 2
CCM value in hexadecimal format (e.g. “00001E” indicates decimal
value 30)
Note: the unsolicited result code +CCCM is sent when the CCM value
changes, but not more than every 10 seconds.
AT+CAOC?
Read command reports the value of parameter <mode> in the format:
+CAOC: <mode>
AT+CAOC=?
Test command reports the supported values for <mode> parameter.
Reference GSM
07.07
Note
+CAOC command returns an estimate of the cost of the current call only,
produced by the MS and based on the information provided by either AoCI
or AOCC supplementary services; it is not stored in the SIM.
3.5.4.3.15 List Current Calls - +CLCC
+CLCC - List Current Calls
SELINT 0 / 1
AT+CLCC
Execution command returns the list of current calls and their characteristics
in the format:
[+CLCC:<id1>,<dir>,<stat>,<mode>,<mpty>,<number>,<type>
[<CR><LF>+CLCC:<id2>,<dir>,<stat>,<mode>,<mpty>,<number>,<typ
e>[…]]]
where:
<idn> - call identification number
<dir> - call direction
0 - mobile originated call
1 - mobile terminated call
<stat> - state of the call
0 - active
1 - held
2 - dialling (MO call)
3 - alerting (MO call)
4 - incoming (MT call)
5 - waiting (MT call)
<mode> - call type
0 - voice
1 - data
2 - fax
9 - unknown
<mpty> - multiparty call flag
0 - call is not one of multiparty (conference) call parties