Rainbow Electronics GM862-QUAD-PY - Manual (Page 307)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 307 of 434
#GAUTH - PPP-GPRS Connection Authentication Type SELINT 0 / 1
0 - no authentication
1 - PAP authentication (factory default)
2 - CHAP authentication
Note: if parameter <type> is omitted the behaviour of Set command is the
same as Read command.
AT#GAUTH? Read command reports the current PPP-GPRS connection authentication
type, in the format:
#GAUTH: <type>
AT#GAUTH=? Test command returns the range of supported values for parameter
<type>.
#GAUTH - PPP-GPRS Connection Authentication Type
SELINT 2
AT#GAUTH=
[<type>] Set command sets the authentication type either for PPP-GPRS and PPP-
GSM connections.
Parameter
<type>
0 - no authentication
1 - PAP authentication (factory default)
2 - CHAP authentication
3 - automatic (PAP and CHAP)
AT#GAUTH? Read command reports the current PPP-GPRS connection authentication
type, in the format:
#GAUTH: <type>
AT#GAUTH=? Test command returns the range of supported values for parameter
<type>.
3.5.7.1.80 PPP-GPRS Parameters Configuration - #GPPPCFG
#GPPPCFG - PPP-GPRS Parameters Configuration SELINT 2
AT#GPPPCFG=
<hostIPaddress>
[,<LCPtimeout>
[,<PPPmode>]] Set command sets three parameters for a PPP-GPRS connection.
Parameters:
<hostIPaddress> - Host IP Address that is assigned to the PPP server
side (the host application); Sstring type, it can be any
valid IP address in the format: xxx.xxx.xxx.xxx.
<LCPtimeout> - LCP response timeout value in 100ms units
10..600 - hundreds of ms (factory default is 25)
<PPPmode> - PPP mode
0 - passive mode (default), the module waits the first message coming
from the remote application (e.g. LCP Conf Req) before starting the
LCP negotiation