Rainbow Electronics GM862-QUAD-PY - Manual (Page 327)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 327 of 434
#FTPOPEN - FTP Open SELINT 0 / 1
1 - passive mode
Note: Before opening an FTP connection the GPRS context must have
been activated by AT#GPRS=1
#FTPOPEN - FTP Open
SELINT 2
AT#FTPOPEN=
[<server:port>,
<username>,
<password>,
<mode>] Execution command opens an FTP connection toward the FTP server.
Parameters:
<server:port> - string type, address and port of FTP server (factory default
port 21).
<username> - string type, authentication user identification string for FTP.
<password> - string type, authentication password for FTP.
<mode>
0 - active mode (factory default)
1 - passive mode
Note: Before opening an FTP connection either the GSM context must have
been activated by AT#SGACT=0,1 or the PDP context #1 must have been
activated by AT#SGACT=1,1 or by AT#GPRS=1
AT#FTPOPEN=? Test command returns the OK result code.
3.5.7.4.3 FTP Close - #FTPCLOSE
#FTPCLOSE - FTP Close SELINT 0 / 1
AT#FTPCLOSE Execution command closes an FTP connection.
AT#FTPCLOSE? Read command behavior is the same as Execution command.
#FTPCLOSE - FTP Close
SELINT 2
AT#FTPCLOSE Execution command closes an FTP connection.
AT#FTPCLOSE=? Test command returns the OK result code.
3.5.7.4.4 FTP Put - #FTPPUT
#FTPPUT - FTP Put SELINT 0 / 1
AT#FTPPUT=
<filename> Execution command, issued during an FTP connection, opens a data
connection, in order to transfer a file to the server.
If the data connection succeeds, a file with name <filename> and initial size
0 is created on the FTP server, a CONNECT indication is sent and it’s
possible to transfer the file; otherwise a NO CARRIER indication is sent.
Parameter:
<filename> - string type, name of the file to create on FTP server.