Rainbow Electronics GM862-QUAD-PY - Manual (Page 315)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 315 of 434
#NWSCANTMR: <tmr>
AT#NWSCANTMR=? Test command reports the supported range of values for parameter <tmr>
Note How much time it takes to execute the network scan depends either on how
much bands have been selected and on network configuration (mean value
is 5 seconds)
3.5.7.2 General Configuration AT Commands - Special Issues
Following commands are available only for specific subsets of products, as it appears in the ‘Note’
3.5.7.2.1 External 32kHz Oscillator
#OSC32KHZ - External 32kHz Oscillator SELINT 2
AT#OSC32KHZ Execution command reports the presence of an external 32kHz oscillator, in
the format:
#OSC32KHZ: <stat>
where:
<stat>
0 - external 32kHz oscillator is not present
1 - external 32kHz oscillator is present
Note: if the external oscillator is removed while the module is on, the
software will take up to 9 seconds to realize its absence.
Note: if the external oscillator is connected to the module while it is on, the
software will take less than 1 second to realize its presence.
AT#OSC32KHZ=? Test command returns the OK result code.
Note This command is currently available only for the product GE864-AUTO
3.5.7.3 Multisocket AT Commands
3.5.7.3.1 Socket Status - #SS
#SS - Socket Status SELINT 2
AT#SS
Execution command reports the current status of the sockets in the format:
#SS: <connId>,<state>,<locIP>,<locPort>,<remIP>,<remPort>
[<CR><LF><connId>,<state>,<locIP>,<locPort>,<remIP>,<remPort>
[…]]
where: