Rainbow Electronics GM862-QUAD-PY - Manual (Page 364)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 364 of 434
#ESMTP - E-mail SMTP Server SELINT 0 / 1
#ESMTP: <smtp>
AT#ESMTP=? Test command returns the max length for the parameter <smtp>.
Example AT#ESMTP="smtp.mydomain.com"
OK
Note The SMTP server used shall be inside the APN space (the smtp server
provided by the network operator) or it must allow the Relay, otherwise it will
refuse to send the e-mail.
#ESMTP - E-mail SMTP Server
SELINT 2
AT#ESMTP=
[<smtp>] Set command sets the SMTP server address, used for E-mail sending.
SMTP server can be specified as IP address or as nick name.
Parameter:
<smtp> - SMTP server address, string type. This parameter can be either:
- any valid IP address in the format: xxx.xxx.xxx.xxx
- any host name to be solved with a DNS query in the format: <host
name>
(factory default is the empty string “”)
Note: the max length for <smtp> is the output of Test command.
AT#ESMTP? Read Command reports the current SMTP server address, in the format:
#ESMTP: <smtp>
AT#ESMTP=? Test command returns the max length for the parameter <smtp>.
Example AT#ESMTP="smtp.mydomain.com"
OK
Note The SMTP server used shall be inside the APN space (the smtp server
provided by the network operator) or it must allow the Relay, otherwise it will
refuse to send the e-mail.
3.5.7.6.2 E-mail Sender Address - #EADDR
#EADDR - E-mail Sender Address SELINT 0 / 1
AT#EADDR
[=<e-addr>] Set command sets the sender address string to be used for sending the e-
mail.
Parameter:
<e-addr> - sender address, string type.
- any string value up to max length reported in the Test command.
(factory default is the empty string “”)
Note: If parameter is omitted then the behaviour of Set command is the
same of Read command
AT#EADDR? Read command reports the current sender address, in the format: