Rainbow Electronics GM862-QUAD-PY - Manual (Page 14)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 14 of 434
Numeric Format Verbose Format
612 resource used by other instance
Network survey errors:
(only if command #SELINT=2 has been issued - see §3.5.2.1.1):
657 Network survey error (No Carrier)*
658 Network survey error (Busy)*
659 Network survey error (Wrong request)*
660 Network survey error (Aborted)*
SAP related errors:
(only if command #SELINT=2 has been issued - see §3.5.2.1.1):
731 Unspecified
732 Activation command is busy
733 Activation started with CMUX off
734 Activation started on invalid CMUX
736 Remote SIM already active
737 Invalid parameter
*(values in parentheses are GSM 04.08 cause codes)
3.2.2.2 Message Service Failure Result Code - +CMS ERROR: <err>
This is NOT a command, it is the error response to +Cxxx GSM 07.05 commands
Syntax: +CMS ERROR: <err>
Parameter: <err> - numeric error code. The <err> values are reported in the table:
Numeric Format Meaning
0...127 GSM 04.11 Annex E-2 values
128...255 GSM 03.40 sub clause 9.2.3.22 values
300 ME failure
301 SMS service of ME reserved
302 operation not allowed
303 operation not supported
304 invalid PDU mode parameter
305 invalid text mode parameter
310 SIM not inserted
311 SIM PIN required
312 PH-SIM PIN required
313 SIM failure
314 SIM busy
315 SIM wrong
316 SIM PUK required
317 SIM PIN2 required
318 SIM PUK2 required
320 memory failure
321 invalid memory index
322 memory full
330 SMSC address unknown
331 no network service
332 network time-out
500 unknown error